Model year

2005 Altec Digger Derrick

Body and fuel not decoded. Owner complaints on file from no date to no date.

Recall campaigns covering this model year415k vehicles or units across those campaigns
Owner complaints0Not enough peers on file
Severity indexNoneCrash, fire, injury or death per 100
First 24 months0Complaints in its first two years
Complaints over time

Complaints about the 2005 Altec Digger Derrick by year filed

Owner complaints about this model year, by the year they were filed with NHTSA.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. The lighter column runs through October.
Components

Complaints by component

Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. A complaint can name more than one component; it is counted under the first.
Recalls

4 recall campaigns cover the 2005 Altec Digger Derrick

Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.

Recall campaigns for the 2005 Altec Digger Derrick
CampaignFiledSubjectComponentVehiclesRemedy
23V-636Sep 14, 2023Incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fallEquipment53Part replacement
19V-127Feb 27, 2019Pedestal tube welds may crack over timeEquipment14,389Repair or modification
18V-255Apr 20, 2018Altec Industries Inc. (Altec) is recalling certain 1992-2006 Digger Derrick trucks that have a specific boom pivot pin which may fail and cause…Structure12Part replacement
14V-503Aug 15, 2014Specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heatElectrical system51Part replacement
Source: NHTSA ODI recalls file.
Owner complaints

What owners reported about the 2005 Altec Digger Derrick

The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.

0 complaints on file.

    Source: NHTSA ODI complaints file.
    Investigations

    NHTSA has not opened an investigation on this model year

    Source: NHTSA ODI investigations file.
    Service bulletins

    5 manufacturer communications cover this model year

    Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.

    • SIL-3214 Jun 18, 2025 · Service Bulletin/Repair Instructions
      Altec has learned that the king pin towing capacity placard might not be installed on certain DL derricks built from August 2005 to October 2024. This could lead to unintentional overloading which could result in cracks or deformations to the king pin assem…
    • SIL-3143 Jun 21, 2024 · Service Bulletin/Repair Instructions
      Altec has learned that a 12-volt Airtronics relay installed in the PDM could have been manufactured to an insufficient threshold on certain units built from December 2004 to October 2022. This can cause the relay to overheat and fail, causing the accessory …
    • SIL 795 Apr 9, 2021 · Service Bulletin/Repair Instructions
      Some customers have reported cracks occurring in the stationary frame tubes above the chassis frame rails of some HD35A pressure diggers built from 2005 through 2020. Investigation has shown this to be caused by improper orientation of the spacer blocks wel…
    • SIL 677 May 14, 2018 · Service Bulletin/Repair Instructions
      This service information letter (SIL) notified customers to inspect the electrical slip ring for proper installation. Slip rings found to be improperly installed are to be replaced.
    • SIL 669 Dec 7, 2017 · Service Bulletin/Repair Instructions
      This service information letter (SIL) notified customers to add a ground wire to the electrical slip ring.
    Source: NHTSA manufacturer communications files.