Complaints about the 2020 Entegra Accolade peaked in 2024, with 1 filed
Owner complaints about this model year, by the year they were filed with NHTSA.
Other, diesel, 4x2, built in United States. Owner complaints on file from Jun 18, 2024 to Nov 3, 2025.
Owner complaints about this model year, by the year they were filed with NHTSA.
Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.
Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.
| Campaign | Filed | Subject | Component | Vehicles | Remedy |
|---|---|---|---|---|---|
| 22V-121 | Mar 3, 2022 | Tire valve stem extension for the inner wheel may come into contact with the outer wheel rim opening and become damaged | Tires | 2,643 | Not stated |
| 20V-337 | Jun 9, 2020 | Adhesive bond between the glass and the metal hinge frame of the frameless crank out vent and egress windows may fail which would then allow the… | Visibility and wipers | 449 | Part replacement |
The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.
2 complaints on file, page 1 of 1.
The contact owns a 2020 Freightliner M2. The contact stated that while driving approximately 10 - 15 MPH and pulling out of the parking lot, the rear passenger’s side window above the kitchen sink started detaching from the vehicle. While driving approximately 60 MPH, the window detached from the vehicle. The contact became aware of NHTSA Campaign Number: 20V337000 (Visibility), and linked the failure to the recall. The vehicle was taken to the dealer, who confirmed that the VIN was not included in the recall. The vehicle was not repaired. The manufacturer was informed of the failure, and a case was opened. The failure mileage was approximately 28,000.
NHTSA complaint 11697105The receiver hitch for trailering is experiencing abnormal metal fatigue and deformation. The motorhome was factory equipped with a receiver hitch that shows a rating of 12,000 lbs and a 1200 lb tongue weight. I have towed both an enclosed trailer with a max weight of less than 4000lbs and a Jeep Gladiator in the flat tow configuration. The Jeep weighs less than 5000 lbs. With both of these towed vehicles being less than 50% of the receivers' rated capacity, I believe there is a manufacturing defect with the supplied receiver hitch. I am certain that had this issue not been detected, continued use would very likely cause a breakaway of the towed vehicle, posing an extreme safety risk as a trailer or Jeep Gladiator breaking away from the motorhome could very likely cause an accident. The receiver hitch is available for inspection. I have reached out to the receiver's manufacturer, Curt Manufacturing and they offered absolutely zero assistance. I have also attempted to contact Entegra/Jayco, but have not received a response.
NHTSA complaint 11595061Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.