Model year

2019 Pleasant Valley Teardrop Trailer

Trailer, Not Applicable, built in United States. Owner complaints on file from Jul 25, 2024 to Jul 25, 2024.

Recall campaigns covering this model year0No recall campaign lists this model year
Owner complaints1Below the median 2019 trailer
Severity index0.02019 trailers average 7.7
First 24 months0Complaints in its first two years
Complaints over time

Complaints about the 2019 Pleasant Valley Teardrop Trailer peaked in 2024, with 1 filed

Owner complaints about this model year, by the year they were filed with NHTSA.

00.250.50.7512024120252026
Source: NHTSA ODI complaints file. The lighter column runs through October.
Components

100% of complaints about the 2019 Pleasant Valley Teardrop Trailer name trailer hitches

Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.

Trailer hitches
1
Source: NHTSA ODI complaints file. A complaint can name more than one component; it is counted under the first.
Recalls

No recall campaign lists the 2019 Pleasant Valley Teardrop Trailer

Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.

Source: NHTSA ODI recalls file.
Owner complaints

What owners reported about the 2019 Pleasant Valley Teardrop Trailer

The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.

1 complaint on file, page 1 of 1.

  1. Filed Jul 25, 2024Failure May 5, 2024Marana, AZTrailer hitches

    I used this carrier 3x (last was in Aug 2021), primarily due to Covid-19, or other travel that did not include use of the carrier. The fourth and last use was on [XXX]. The carrier was securely mounted to the A-frame of my travel trailer, as per the mfg's instructions. I had driven 150 miles from my home (via U.S. Interstates XXX and XXX), when I stopped at a rest area near Gila Bend, AZ, to stretch my legs. When I exited my truck, I observed the carrier support system had failed. My two "Specialized" brand bicycles, weighing 30 lbs. each, were leaning back at a 45-degree angle from their original vertical position. The carrier is rated to support up to 80 lbs. For unknown reasons, the steel "Y-base" (aka Stem) arms had failed (i.e., the steel arms bent/twisted backward), allowing both bikes to lean backward, causing them to repeatedly bang against the aluminum roof of my trailer, resulting in damage to the trailer. Fortunately, the bikes did not fall off the carrier. They were secured with the carrier tie-down straps and my cable locks. I have contacted both Let's Go Aero (original designer) and Lippert Components on multiple occasions seeking compensation for the damages caused, pursuant to the implied warranty of merchantability. But, I primarily wanted to inform them of the failure and safety concerns. Both companies denied responsibility, relying on the one-year product warranty having expired (which I did not deny.) Neither expressed any intent to investigate further to determine the cause, or to report my concerns to the CPSC, NHTSA, or consumers. I am unaware of the same specific failure being reported by others, but I have read multiple online reports (some with photos) of weld and steel split failures (generally b/w 2018-2020.) One report described a bicycle falling off the carrier and onto the side of a highway. The Jack-IT continues to be sold. See also: [XXX] . INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

    NHTSA complaint 11604608
Source: NHTSA ODI complaints file.
Investigations

NHTSA has not opened an investigation on this model year

Source: NHTSA ODI investigations file.
Service bulletins

No manufacturer communications on file

Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.

Source: NHTSA manufacturer communications files.