AutoStatsIQ
Data through Oct 2026
Model year

2012 Prevost H3-40

Body and fuel not decoded. Owner complaints on file from no date to no date.

Recalls (0)Complaints (0)Investigations (1)Bulletins (37)
Recall campaigns covering this model year0No recall campaign lists this model year
Owner complaints0Not enough peers on file
Severity indexNoneCrash, fire, injury or death per 100
First 24 months0Complaints in its first two years
Complaints over time

Complaints about the 2012 Prevost H3-40 by year filed

Owner complaints about this model year, by the year they were filed with NHTSA.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. The lighter column runs through October.
Components

Complaints by component

Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. A complaint can name more than one component; it is counted under the first.
Recalls

No recall campaign lists the 2012 Prevost H3-40

Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.

Source: NHTSA ODI recalls file.
Look up a VIN at NHTSA
Owner complaints

What owners reported about the 2012 Prevost H3-40

The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.

0 complaints on file.

    Source: NHTSA ODI complaints file.
    Investigations

    1 NHTSA investigation on file

    • PE21011 Preliminary evaluation, Electrical system
      Alternator Front Bearing Failure
      Opened May 13, 2021, closed Oct 3, 2022 · led to a recall
    Source: NHTSA ODI investigations file.
    All investigations
    Service bulletins

    37 manufacturer communications cover this model year

    Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.

    • MI26-00 Feb 3, 2026 · Service Bulletin/Repair Instructions
      The gasket thickness was increased from 1.5 mm to 3 mm to prevent interference between the collar ends, which previously made it impossible to reach the specified tightening torque. Increasing the gasket thickness ensures sufficient clearance between the co…
    • IS-23019A Jun 4, 2024 · Service Bulletin/Repair Instructions
      Sway bar collars improvement. Revision A : Add front sway bar support replacement and change bolts lenght.
    • IS-23019 Dec 14, 2023 · Service Bulletin/Repair Instructions
      SWAY BAR COLLARS IMPROVEMENT
    • MI22-12B Dec 7, 2022 · Service Bulletin/Repair Instructions
      Air Tanks Draining Sequence. Revision: B - General Update
    • MI22-12A Nov 17, 2022 · Service Bulletin/Repair Instructions
      Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
    • MI22-12 Nov 2, 2022 · Service Bulletin/Repair Instructions
      Air Tanks Draining Sequence
    • IS-22902 Sep 15, 2022 · Service Bulletin/Repair Instructions
      TAG AXLE HUB FLANGE - ALTERNATE CAP SCREW
    • IS21-072 Aug 17, 2022 · Service Bulletin/Repair Instructions
      STEERING GATEWAY, revision A : Cancel watch dog removal from EFD part of the instruction
    • MI20-08C Jul 13, 2022 · Service Bulletin/Repair Instructions
      STORAGE AND STARTUP GUIDELINES : part number updates
    • IS21-072A Jun 29, 2022 · Service Bulletin/Repair Instructions
      STEERING GATEWAY Revision A Cancel watch dog removal from EFD part of the instruction
    • IS20-925A Jun 13, 2022 · Service Bulletin/Repair Instructions
      CENTRAL HVAC MERV FILTERS INSTALLATION
    • IS20-932A May 25, 2022 · Service Bulletin/Repair Instructions
      H3 SERIES ENVIROCARE - IONS AIR SANITIZER
    • MI18-16B Jan 19, 2022 · Service Bulletin/Repair Instructions
      BOSCH HD10 ALTERNATOR DIAGNOSTIC GUIDE Revision B To avoid replacement of alternators that are in fact in good working order, perform the steps which follow to help you perform a more precise diagnosis.
    • MI21-06 Nov 17, 2021 · Service Bulletin/Repair Instructions
      Diesel Exhaust Fluid ( DEF ) Contamination In Fuel System, Inspection And Repair – From US10 to newer engine generation
    • Mi21-07A Sep 21, 2021 · Service Bulletin/Repair Instructions
      RONT & TAG AXLE – UNITIZED HUB BEARING END PLAY VERIFICATION AND REPLACEMENT
    • is_20089 Sep 27, 2021 · Service Bulletin/Repair Instructions
      LAVATORY COMPARTMENT SLIDING DOOR LATCH IMPROVEMENT
    • MI20-08C Jun 3, 2021 · Service Bulletin/Repair Instructions
      STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guideli…
    • IS-20925A Jun 15, 2021 · Service Bulletin/Repair Instructions
      CENTRAL HVAC MERV FILTERS INSTALLATION REVA
    • IS-20932A Jun 21, 2021 · Service Bulletin/Repair Instructions
      H3 SERIES ENVIROCARE - IONS AIR SANITIZER REV A
    • IS-20932 Jun 1, 2021 · Service Bulletin/Repair Instructions
      H3 SERIES ENVIROCARE - IONS AIR SANITIZER
    • IS-20025A Apr 5, 2021 · Service Bulletin/Repair Instructions
      PREVOST AWARE ADAPTIVE CRUISE BRAKING (ACB) – FLR10 TO FLR21 RADAR SENSOR UPGRADE APPLICABLE TO: H3 SERIES VEHICLES EQUIPPED WITH ACB SYSTEM FLR10 RADAR SENSOR
    • IS-18091A Apr 5, 2021 · Service Bulletin/Repair Instructions
      TIE ROD 610052 FIRST INSTALLATION INSTRUCTIONS: Use these instructions when replacing the drop joint tie rod on S82, S84 / S84U I-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment needs to be perform…
    • MI20-19B Feb 4, 2021 · Service Bulletin/Repair Instructions
      INTRODUCING A NEW ENGINE COOLANT INTO PREVOST SERVICE CENTER NETWORK
    • MI20-19A Jan 15, 2021 · Service Bulletin/Repair Instructions
      Rev A: Mention added concerning DDC Series 60 engine SCA requirement
    • MI21-01 Jan 15, 2021 · Service Bulletin/Repair Instructions
      VOLVO I-SHIFT TRANSMISSION REPLACEMENT - DIFFERENCE BETWEEN CONNECTIONS AT THE TOP OF THE OIL FILTER HOUSING
    • MI21-01 Jan 15, 2021 · Service Bulletin/Repair Instructions
      VOLVO I-SHIFT TRANSMISSION REPLACEMENT - DIFFERENCE BETWEEN CONNECTIONS AT THE TOP OF THE OIL FILTER HOUSING
    • MI20-19 Dec 21, 2020 · Service Bulletin/Repair Instructions
      INTRODUCING A NEW ENGINE COOLANT INTO SERVICE
    • MI20-08B Aug 10, 2020 · Service Bulletin/Repair Instructions
      STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
    • MI20-12 Jul 10, 2020 · Service Bulletin/Repair Instructions
      JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models – equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
    • MI20-08A Jun 10, 2020 · Service Bulletin/Repair Instructions
      STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
    • NOx_Conv2 Mar 1, 2020 · Service Bulletin/Repair Instructions
      Repair instructions to address fault codes P207F-00; P20EE-00
    • NOX_Conv1 Mar 1, 2020 · Service Bulletin/Repair Instructions
      Repair instructions to address fault codes P207F-00 - Reductant Quality
    • MI20-09 Apr 24, 2020 · Service Bulletin/Repair Instructions
      PREVOST VEHICLE DISINFECTION PROCEDURE
    • MI20-08 Apr 20, 2020 · Service Bulletin/Repair Instructions
      STORAGE AND STARTUP GUIDELINES - ALL PREVOST VEHICLES & VOLVO 9700
    • MI15-24 Mar 25, 2020 · Service Bulletin/Repair Instructions
      Added: Power cables for L.H. side alternator & fan drive breaker box
    • IS-19921A Dec 18, 2019 · Service Bulletin/Repair Instructions
      This instruction Sheet explains how to install a seatbelt cutter in the driver's area
    • IS-08080A Sep 21, 2016 · Service Bulletin/Repair Instructions
      WHEN REPLACING A VEHICLE SOUND SELECTOR MODEL VSS04 WITH A NEW SOUND SELECTOR MODEL VSS05, AN INTERFACE HARNESS IS REQUIRED TO CONNECT THE VEHICLE HARNESS TO THE NEW SOUND SELECTOR MODEL AND A NEW VSS05 COMPATIBLE RADIO UNIT MUST ALSO BE INSTALLED. THIS PRO…
    Source: NHTSA manufacturer communications files.
    About service bulletins