Body and fuel not decoded. Owner complaints on file from no date to no date.
Owner complaints about this model year, by the year they were filed with NHTSA.
Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.
Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.
| Campaign | Filed | Subject | Component | Vehicles | Remedy |
|---|---|---|---|---|---|
| 25V-562 | Aug 29, 2025 | Cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle | Structure | 903 | Part replacement |
| 23V-636 | Sep 14, 2023 | Incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall | Equipment | 53 | Part replacement |
| 19V-365 | May 13, 2019 | Slope indicator placard card may falsely indicate that the unit could be used without leveling on a 5 degree slope | Equipment | 1,036 | Label or owner notice |
| 19V-127 | Feb 27, 2019 | Pedestal tube welds may crack over time | Equipment | 14,389 | Repair or modification |
| 18V-791 | Nov 9, 2018 | Wiring on the 12V circuit from the chassis battery to the Power Distribution Module (PDM) may be insufficiently sized | Electrical system | 331 | Part replacement |
| 15V-101 | Feb 23, 2015 | In the event of a short circuit condition, the 30 amp breaker to the trailer relay module may react too slowly to prevent the module from overheating | Electrical system | 5,142 | Part replacement |
| 14V-503 | Aug 15, 2014 | Specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat | Electrical system | 51 | Part replacement |
| 13V-636 | Dec 18, 2013 | Fasteners that hold the bracket for the feeder tube (the telescopic hydraulic tube that supplies pump flow to the auger) may become loose allowing… | Equipment | 661 | Repair or modification |
| 13V-390 | Aug 28, 2013 | Bolts that attach the winch motor to the winch may not be properly tightened and may become loose | Equipment | 1,743 | Repair or modification |
| 13V-141 | Apr 11, 2013 | In the affected vehicles, the winch drum could deform or fracture | Equipment | 1,057 | Part replacement |
| 12V-423 | Aug 30, 2012 | Defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material | Equipment | 2,193 | Part replacement |
The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.
0 complaints on file.
Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.