Model year

2021 Honda GL1800

Motorcycle, gasoline, built in Japan. Owner complaints on file from Jul 20, 2021 to Jun 18, 2025.

Recall campaigns covering this model year349k vehicles or units across those campaigns
Owner complaints77.0 times the median 2021 motorcycle
Severity index14.32021 motorcycles average 5.8
First 24 months4Complaints in its first two years
Complaints over time

Complaints about the 2021 Honda GL1800 peaked in 2021, with 3 filed

Owner complaints about this model year, by the year they were filed with NHTSA.

01232021320222023202420252026
Source: NHTSA ODI complaints file. The lighter column runs through October.
Components

43% of complaints about the 2021 Honda GL1800 name speed control

Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.

Speed control
3
Electrical system
2
Brakes
2
Steering
2
Engine and cooling
1
Fuel system
1
Structure
1
Suspension
1
Source: NHTSA ODI complaints file. A complaint can name more than one component; it is counted under the first.
Recalls

3 recall campaigns cover the 2021 Honda GL1800

Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.

Recall campaigns for the 2021 Honda GL1800
CampaignFiledSubjectComponentVehiclesRemedy
24V-820Oct 31, 2024Primary drive gear bolt on the crankshaft may break, which can result in an engine stall and lock up the rear wheelEngine and cooling18,196Part replacement
24V-113Feb 15, 2024Fuel pump impellers may have been improperly molded, which can cause them to deform and result in fuel pump failureFuel system29,301Part replacement
22V-449Jun 23, 2022Ignition timing software error for the engine control unit (ECU) may reduce engine performance, which can result in an engine stallEngine and cooling1,740Software update
Source: NHTSA ODI recalls file.
Owner complaints

What owners reported about the 2021 Honda GL1800

The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.

7 complaints on file, page 1 of 1.

  1. Filed Jun 18, 2025Failure Apr 18, 202522,000 milesGreenville, TXSteering wheel/handle bar

    The contact owns a 2021 Honda GL1800 Motorcycle. The contact stated that while operating the motorcycle, the handlebars had become loose and were wobbly. Upon inspection, the contact discovered that the nut used to secure the handlebars was loose. The contact tightened the steering nut, but eventually the failure reoccurred. The local dealer was notified of the failure, but no assistance was provided. The manufacturer was not yet been contacted. The failure mileage was 22,000.

    NHTSA complaint 11667669
  2. Filed Apr 19, 2024Failure Jul 15, 2021Deridder, LASteering, Body, Suspension

    Shortly after purchasing brand new in July of 2021, this motorcycle developed a violent shake and wobble at 40mph, which could be felt between 35mph and 45mph, but was much worse at 40mph. It also developed at the same time a constant, uncommanded pull to the right. I have tried for three years to get this problem fixed and addressed under warranty. I have not been successful thus far. I have spent thousands of dollars myself because I have not gotten resolution from the manufacturer or dealer, and to this date, April 19, 2024, it is unresolved. You should know that there are many riders that own the 2018+ model of the Honda Gold Wing GL1800 that have the same issues. Not all, but enough that it is a common finding online, with professionals saying that they believe 1 out of every 1000 of these bikes have a bent or twisted frame, to a very well documented (by Traxxion Dynamics) defect in the right tie rod due to inferior components. I feel like I a being ignored until my warranty expires. I can provide extension high quality footage of these issues. I have included my letter to Honda Corporation, as well as a timeline of events since purchase. Please help.

    NHTSA complaint 11584058
  3. Filed Nov 4, 2022Failure Nov 4, 2022Mechanicsburg, PAService brakes

    Found that the front brake rotors were on the wrong side. Honda specifies different part numbers for each rotor. Went to dealer to resolve this issue and express my concern about it being a safety issue. The dealer contacted Honda, and they agreed to pay to have the rotors installed the right way and replace the brake pads. But not replace the rotors. My concern is after 14000 miles they are now the rotors are rotating in the opposite. And that this may have compromised structural integrate of the rotors themselves

    NHTSA complaint 11492330
  4. Filed Jan 30, 2022Failure Jan 30, 2022Houston, TXElectrical system, Vehicle speed controlCrash

    I was pulling into a parking spot to turn the bike around and back into the spot. While sitting sideways in a parking spot, I increased the throttle slightly to pull forward. The throttle acted as if it was stuck and the bike lurched forward after I released the throttle. I applied the front brake but the bike continued moving forward pushing the front tire which left a skid mark on the pavement. I continued forward until the bike ran into the driver's door of a parked car. This was the second time the throttle stuck in this manner. The first time I was leaving my driveway when the bike acted in the same manner and caused me to run over some Christmas lights on the edge of my driveway. The first time I did not realize what happened therefore I did not file a complaint. I researched this on a motorcycle forum and found many instances of other GL 1800 owners experiencing the same problem.

    NHTSA complaint 11449495
  5. Filed Sep 10, 2021Failure Jul 15, 2021Portland, TNVehicle speed control

    At approximately 800 miles, the throttle became sticky. The return spring will close the throttle; however, there is excessive friction that developed while riding. Temperatures were approximately 85-95 degrees. The problem is that fine feathering of the throttle is not possible. By the time enough hand control pressure is released to ease off the throttle, the throttle closes aggressively and by the time I can stop the throttle closure, the engine and dual clutch transmission are downshifting--in Sport mode the downshifts are aggressive and vehicle speed decelerates more than desired. Worse, this condition occurred while riding US129 in Tennessee and North Carolina at inopportune time such as at the apex of a curve. This resulted in the motorcycle changing lean angle and straying from the intended arc through the curve. Other instances happened when encountering slow traffic and the throttle needs to be feathered to slow. The motorcycle engine and dual clutch transmission interpret this larger throttle closure as an intent to slow resulting in unintentional downshifts and excessive speed reduction. Not an ideal situation with traffic following closely because the brake lights are not activated leaving the drivers behind the motorcycle wondering what is happening. To continue riding with the throttle in this condition, the rider has to increase throttle twist force and counter twist force in an attempt to control. This technique doesn't really help and should not be required to ride a motorcycle. This condition has been brought to the attention of the selling dealership service department for which they contacted a Honda technical representative whom never heard of this condition. Therefore, no action was taken to date. This sticky throttle condition can be seen on new Goldwings sitting on the showroom floor; however, the friction/stickiness is not to the degree being experienced at 800.

    NHTSA complaint 11432523
  6. Filed Aug 11, 2021Failure Aug 11, 2021Mccalla, ALFuel/propulsion system, Vehicle speed control

    The throttle is sticking open at low speeds that makes for a dangerous situation dealer could not duplicate at time of visit the throttle is sticky will not operate smooth no accident has happened at this time

    NHTSA complaint 11428738
  7. Filed Jul 20, 2021Failure Jun 12, 2021Brooksville, FLElectrical system, Engine, Service brakes

    when just starting out using foot brake and handbrake , handbrake came in towards grip real far and throttle cut out but not off for a few seconds. Then abs and traction control lights came on along with mode selector lights until bike was shut down and restarted. Upon restarting all would be ok for a few miles or even the whole day or would just do it all over again. It did this from june until now where it is presently at the honda dealer while honda tries to figure it out. So far they have not.

    NHTSA complaint 11425731
Source: NHTSA ODI complaints file.
Investigations

NHTSA has not opened an investigation on this model year

Source: NHTSA ODI investigations file.
Service bulletins

4 manufacturer communications cover this model year

Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.

  • The Wrench - May May 19, 2022 · Service Bulletin/Repair Instructions
    "Newsletter - If the LCD screen is blank/inoperative and asterisks appear in place of the riding modes, perform the following test. • Inspect the number five (15 amp) audio fuse next to the battery in the main fuse box. • If failed, replace the fuse and…
  • TheWrench1Feb.21 Feb 19, 2021 · Service Bulletin/Repair Instructions
    The Wrench - When performing the Service Bulletin GL1800 #1- Loose Handlebar Repair on 2018 GL 1800, or removing the Steering Bridge to adjust the upper steering stem nut on any 2018 and newer GL1800, the left rear tie rod bolt needs to be held by a 14 mm o…
  • AMV200502 May 8, 2020 · Service Bulletin/Repair Instructions
    Video Message - It concerns how to replace a leaky front rocker arm oil control valve. Due to a deteriorated lower gasket or an out-of-spec gasket groove, the front rocker arm oil control valve can leak in certain V6 models with variable cylinder management…
  • AMV200501 May 11, 2020 · Service Bulletin/Repair Instructions
    Video Message - It concerns how to replace a leaky front rocker arm oil control valve. Due to a deteriorated lower gasket or an out-of-spec gasket groove, the front rocker arm oil control valve can leak in certain V6 models with variable cylinder management…
Source: NHTSA manufacturer communications files.