Model year

2000 Pierce Custom Contender

Body and fuel not decoded. Owner complaints on file from no date to no date.

Recall campaigns covering this model year16,803 vehicles or units across those campaigns
Owner complaints0Not enough peers on file
Severity indexNoneCrash, fire, injury or death per 100
First 24 months0Complaints in its first two years
Complaints over time

Complaints about the 2000 Pierce Custom Contender by year filed

Owner complaints about this model year, by the year they were filed with NHTSA.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. The lighter column runs through October.
Components

Complaints by component

Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.

No campaigns match these filters.Reset filters
Source: NHTSA ODI complaints file. A complaint can name more than one component; it is counted under the first.
Recalls

One recall campaign covers the 2000 Pierce Custom Contender

Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.

Recall campaigns for the 2000 Pierce Custom Contender
CampaignFiledSubjectComponentVehiclesRemedy
11V-384Jul 26, 2011Pierce has decided that certain model year 1995-2008 arrow xt, dash, custom contender, lance, enforcer, pierce arrow, quantum, saber and…Fuel system6,803Part replacement
Source: NHTSA ODI recalls file.
Owner complaints

What owners reported about the 2000 Pierce Custom Contender

The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.

0 complaints on file.

    Source: NHTSA ODI complaints file.
    Investigations

    NHTSA has not opened an investigation on this model year

    Source: NHTSA ODI investigations file.
    Service bulletins

    11 manufacturer communications cover this model year

    Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.

    • SB_651_1 Nov 15, 2024 · Service Bulletin/Repair Instructions
      This bulletin is to support the dealer network when replacing a ASL 360 ECU that requires programming on the truck.
    • SB_474_1 Oct 30, 2024 · Service Bulletin/Repair Instructions
      Software update for fault codes on Command Zone display: This software update may help remove ambiguity between active and inactive engine error codes shown on the Command Zone display.
    • SB_717 Oct 30, 2024 · Service Bulletin/Repair Instructions
      Alternators with a voltage sense terminal must have a voltage sense wire installed between the sense terminal of the alternator and a positive stud of a battery in the main battery bank. The voltage sense wire provides a more accurate voltage measurement to…
    • SB_716 Oct 30, 2024 · Service Bulletin/Repair Instructions
      Historically, the main battery cable for the mechanical siren was attached to the cab power distribution area. The large draw of electrical current from the mechanical siren activation, would starve other electronics in the cab. Sometime causing HVAC system…
    • SB_715 Oct 30, 2024 · Service Bulletin/Repair Instructions
      Pierce apparatus equipped with Command Zone multiplexing uses the cab power distribution area for determining the vehicle system voltage. However, because of voltage drop between the batteries and the cab distribution area, this is not a true representation…
    • WB_706 Sep 4, 2024 · Warranty Program/Extension
      All Roto Rays are warranted to the purchaser for twenty-four months from the date of service against defects in material or workmanship. During the warranty period products found to be defective will be repaired or replaced (at Roto Rays option) without cha…
    • SB_709 Oct 2, 2024 · Service Bulletin/Repair Instructions
      This bulletin will provide torque ratings for constant torque clamps that are used to secure coolant hoses on Pierce Custom Chassis vehicles. See table below for details.
    • SB_710 Oct 2, 2024 · Service Bulletin/Repair Instructions
      This bulletin will outline and standardize a procedure for gathering HVAC system information for under-performing HVAC units. Please fill out information and perform the following tasks that are included in the checklist below, prior to submitting a technic…
    • SB_702 Jul 24, 2024 · Service Bulletin/Repair Instructions
      The purpose of this bulletin is to reduce labor hours by standardizing the location(s) of the unused legs of the SRP harness that contain resistors. This will help technicians in the field perform diagnostics without removing unnecessary panels while search…
    • PB_663 Nov 6, 2023 · Service Bulletin/Repair Instructions
      As a product improvement, Pierce will be changing coolant probes from a contact probe to a capacitive sensor.
    • SB_446.1 Apr 18, 2022 · Service Bulletin/Repair Instructions
      The GEN 1 Husky 3 foam pump from FSC is being discontinued. To keep supporting our customers, a conversion kit is available to install the GEN 2 Husky 3 foam pump in place of the GEN 1.
    Source: NHTSA manufacturer communications files.