Body and fuel not decoded. Owner complaints on file from no date to no date.
Owner complaints about this model year, by the year they were filed with NHTSA.
Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.
Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.
| Campaign | Filed | Subject | Component | Vehicles | Remedy |
|---|---|---|---|---|---|
| 25V-562 | Aug 29, 2025 | Cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle | Structure | 903 | Part replacement |
| 24V-362 | May 23, 2024 | Hydraulic cylinder feeder tube routed near the cylinder rest bracket may become damaged and leak oil, which can result in uncontrolled boom movement | Equipment | 1,128 | Part replacement |
| 24V-015 | Jan 11, 2024 | Cables in the engine compartment may contact the vehicle's hood, damaging the cables and causing a short circuit | Electrical system | 437 | Repair or modification |
| 23V-824 | Dec 7, 2023 | Welder may be misaligned, preventing the mounting fasteners from being properly tightened | Structure | 43 | Repair or modification |
| 23V-438 | Jun 22, 2023 | Inverter-powered outlet may have been installed at the aerial boom tip without ground-fault interrupter (GFCI) protection | Electrical system | 18 | Repair or modification |
| 23V-395 | Jun 1, 2023 | Collision mitigation system software may not be calibrated correctly, prohibiting the active braking system from activating | Driver assistance | 59 | Software update |
| 23V-357 | May 18, 2023 | Water can leak into the strobe lights, which could cause an electrical short-circuit | Equipment | 5,431 | Part replacement |
| 23V-216 | Mar 30, 2023 | Base of the rear pole rack may be missing a weld | Structure | 1,967 | Part replacement |
| 22V-794 | Oct 21, 2022 | Material handling interlocking valve may lose power when the outriggers are not set, allowing the jib winch to be operated while the outriggers are up | Equipment | 71 | Repair or modification |
| 22V-613 | Aug 10, 2022 | Weld between the base boom and the auger stow bracket could crack | Equipment | 975 | Repair or modification |
| 22V-577 | Aug 4, 2022 | Wire to the boom stow sensor may be routed over a sharp edge, which can expose the wire to metal and result in a blown ignition circuit fuse | Electrical system | 594 | Repair or modification |
| 22V-147 | Mar 11, 2022 | Chassis fuel line clamps may not have been secured properly after they were removed to install an aftermarket accessory | Fuel system | 27,270 | Repair or modification |
| 22V-146 | Mar 11, 2022 | Vehicles are not equipped with carbon monoxide detectors | Equipment | 46 | Repair or modification |
| 22V-072 | Feb 9, 2022 | Bolts in the rotation bearing outer-race may have been over-tightened, allowing the bolts to break | Equipment | 454 | Part replacement |
| 22V-071 | Feb 9, 2022 | Unit subbase may develop cracks in the bulkhead plate, which can cause the shear plates to fail | Equipment | 167 | Repair or modification |
| 22V-060 | Feb 3, 2022 | When operating the boom positioning control lever, a defective linear potentiometer may cause the boom to move in an unintended direction | Equipment | 47 | Part replacement |
| 22V-058 | Feb 3, 2022 | Outer-race rotation bearing bolt washers may interfere with an adjacent pedestal weld, which could cause the rotation bearing bolts to break | Equipment | 157 | Repair or modification |
| 21V-998 | Dec 20, 2021 | Hydraulic plumbing to the lift cylinders of the lower and upper booms could be connected incorrectly, allowing the boom to overextend | Equipment | 150 | Inspection |
| 21V-722 | Sep 16, 2021 | Outer-race rotation bearing bolt washers may interfere with an adjacent pedestal weld, which could cause the rotation bearing bolts to break | Equipment | 94 | Repair or modification |
| 21V-709 | Sep 13, 2021 | Cylinder rod threads may not have been machined properly, which could result in uncontrollable boom movement | Equipment | 29 | Part replacement |
| 21V-464 | Jun 18, 2021 | Bolts of insufficient strength may have been used to connect the pedestal and sub-base, which could cause the bolts to become overloaded | Equipment | 218 | Part replacement |
| 21V-409 | Jun 1, 2021 | Lower and upper boom raise spools can shift after releasing the joystick or control interlock | Equipment | 1,977 | Part replacement |
The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.
0 complaints on file.
Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall.