Wagon, gasoline, built in Germany. Owner complaints on file from Feb 13, 2022 to Jun 26, 2026.
Owner complaints about this model year, by the year they were filed with NHTSA.
Owner complaints by component. Hover or focus a bar for the crash, fire, injury or death count.
Check a specific vehicle by VIN on NHTSA's site: a campaign may cover only part of a model year's production.
| Campaign | Filed | Subject | Component | Vehicles | Remedy |
|---|---|---|---|---|---|
| 21V-229 | Apr 1, 2021 | Steering shaft bore hole for the universal joint bearing may allow excessive movement that, over time, could result in the separation of the… | Steering | 4,992 | Part replacement |
| 21V-058 | Feb 5, 2021 | Software design of the communication module may fail to communicate the correct vehicle location for the emergency call system (eCall) in the… | Communication | 1,292,258 | Software update |
| 17V-627 | Oct 6, 2017 | Driver's air bag may unexpectedly deploy due to insufficient grounding of the steering components if an electrostatic discharge occurs and the air… | Airbags | 495,290 | Not stated |
The full text of every complaint filed with NHTSA about this model year, newest first. Complaints are filed by owners and are not verified by NHTSA; NHTSA removes personal details before publishing.
2 complaints on file, page 1 of 1.
The instrument cluster would fail intermittently, the speedometer would be my accurate speed, and then suddenly 0. Same for RPMs, gas, etc. Then after a period of time they would work again. Some times is was just oscillating back and forth between the failure modes. My blinkers would be on, but the instrument cluster and "click" would be out of sync. The "hold" feature that would hold the break was unavailable during the error state. All the instrument cluster lights would be blinking on and off rapidly. (have video)
NHTSA complaint 11746825I was driving the car at about 70 mph on an interstate highway during "rush hour" traffic when the Electronic Stabilization icon flashed on the dashboard screen and the car began to decelerate. I pressed on the accelerator pedal but the car continued to coast. A second or two later the dashboard screen flashed a warning stating something like "Brake assist activated" and the vehicle began to aggressively brake. I was in the middle lane of the interstate with vehicles around me travelling at 65 to 75 miles per hour and I could see a car rapidly approaching me from behind. It was apparent to me that my vehicle was going to come to a rapid stop in the middle of a busy interstate highway and that I was going to be struck from behind by one or more cars travelling at a high rate of speed. I did not think that I would survive such an impact and checked the right hand lane and noted no vehicles. Since all I could do with the car at that point was steer, I pulled my car into the right hand lane, attempting to avoid an inevitable high speed rear end collision. Unfortunately by that time my vehicle was still braking and travelling at a relatively low speed and was struck in the right rear area by another vehicle that was travelling at a much higher speed. Fortunately no one was injured in this crash, but there was extensive damage to both vehicles. I had not previously experienced this type of malfunction of the emergency collision avoidance system but on reviewing Mercedes Benz owners' blogs it is clear that this is not an isolated occurrence. I note that the owners of other car manufacturers have also experienced issues similar to mine, although most of them occurred in less dangerous situations and did not result in a crash. I believe that this "safety" system is flawed and placed my life, and the lives of others, in grave danger, much like the Boeing 737 Max issue, and that a recall and investigation is needed to prevent fatalities resulting from their malfunction.
NHTSA complaint 11451776Technical service bulletins and other notices the manufacturer sent to dealers. A bulletin is not a recall; the 60 most recent are listed.